一、j濟南空壓機的運行環境中如果帶有腐蝕性或刺激性的氣體，如硫化物、清洗用的化學製劑等發在空氣中。壓縮機本身的高溫就加速了機油的氧化，一旦這些氣體進入空壓機係統內，就會與潤滑油發生化學反應，從而產生積碳和油泥等。一部分雜質進入潤滑油循環係統會被油過濾器攔截，而另一部分的雜質會隨著油氣混合物上升到油分，在氣體通過油分時，這些雜質滯留在油分濾紙上，將過濾孔堵塞，油分的阻力就會慢慢增大，致使油分在較短的時間內就需要提前更換。

1. If the air compressor operates in a corrosive or irritating gas, such as sulphides and chemicals used in cleaning, it will be in the air. The high temperature of the compressor itself accelerates the oxidation of the oil. Once the gas enters the air compressor system, it will react with the lubricating oil to produce carbon and sludge. Some impurities entering the lubricating oil cycle system will be intercepted by the oil filter, and the other part of the impurities will rise to the oil and gas mixture with the oil and gas mixture. When the gas passes the oil, the impurities are stuck on the oil filter paper, the filter holes are blocked and the oil separation resistance will gradually increase, resulting in the oil in a short time. Change in advance.

二、一般情況下，溫度越高，空壓機的排氣溫度就越高，而且排氣溫度就越難控製。如果工作的環境溫度高，那麽其空氣的壓強也就越小，很難發揮出空壓機的應有作用。

Two, under normal circumstances, the higher the temperature, the higher the exhaust temperature of the air compressor, and the more difficult it is to control the exhaust temperature. If the temperature of the working environment is high, the pressure of the air will be smaller. It is very difficult to play the proper role of the air compressor.

三、過濾精度差的空氣過濾器會讓部分空氣中的粉塵顆粒無法被攔截，而直接進入空壓機係統，使油濾和油分的負荷過大，導致油濾和油分過早出現堵塞。

Three, the filter precision of the air filter can not be intercepted in some air dust particles, and directly into the air compressor system, so that the oil filter and oil load is too large, leading to oil filtration and oil separation too early.

四、油分濾材上的水份過多會使濾材發脹、微孔收縮，使油分的有效分離麵積減少，導致油分的阻力增大，油分提前堵塞。

Four. The excessive moisture on the oil filter material will cause the expansion of the filter material and the shrinkage of the micropores, so that the effective separation area of the oil can be reduced, the resistance of the oil is increased and the oil separation is blocked in advance.

濟南空壓機

五、當機組停機後外部的氣流會隨著小壓力閥的泄漏處回流到油分，由於溫度和氣壓的同時降低會使氣體凝結成水滴，水滴進入油分就會使濾材吸水發脹變質。

Five, when the unit is shut down, the air flow will return to the oil point with the leakage of the minimum pressure valve. As the temperature and air pressure decrease at the same time, the gas will be condensed into water droplets, and the water drops into the oil will make the filter swollen and deteriorate.

因此，為了延長生產企業的空壓機使用壽命，空壓機在進行運作的時候，一定要注意以下七大注意事項：

Therefore, in order to extend the service life of air compressors in production enterprises, we must pay attention to the following seven points when operating the air compressors:

1、需要為空壓機正常作業營造一個穩定的運行環境，那麽就需要保持機站內衛生清潔、空氣幹燥、通風效果良好，比如：儲氣罐等需要放在通風良好避免在高溫環境的直接烘烤與陽光直接照射引起暴曬。

1, it is necessary to create a stable and efficient operation environment for the high efficiency and normal operation of the air compressor, so it is necessary to keep clean, dry air and good ventilation in the station. For example, the storage tank and so on need to be put in a good ventilation to avoid direct roasting and direct sunlight exposure in the high temperature environment.

2、其壓力不允許超越規定範圍值。

2, its maximum pressure is not allowed to exceed the maximum range.

3、確保閥是靈敏有效的。

3, ensure that the safety valve is sensitive and effective.

4、針對儲氣罐、輸氣管道必須每隔兩年時間為一個周期對其進行測試是否正常需要更換等。

4, for gas storage tanks, gas pipelines must be tested every two years for a period of normal replacement.

5、當我們啟動機器的時候一定是在其沒有負荷下開始運載，等到一切正常後才開始逐漸進到載荷運轉。

5, when we start the machine, we must start loading without any load, and wait until everything is normal before we start to load gradually.

6、禁止在空壓機出氣口麵前站人，當需要開啟送氣閥之前，應該將相應的輸氣管道都完好保持其通暢。

6. It is forbidden to stand in front of the outlet of the air compressor. When the valve is needed to be opened, the corresponding gas transmission pipeline should be kept intact.

7、當出現漏電、漏氣、漏油、漏水、各參數值超過規定範圍值時等等這些情況時應該馬上停止空氣壓縮機進行檢查，查找分析故障把故障排除後方可恢複正常的運行。

7, when the leakage, gas leakage, oil leakage, leakage, the value of all the parameters exceed the specified range and so on, we should immediately stop the air compressor to check, find out the fault to remove the fault and restore the normal operation.